Bartscher SNACK Mode D'emploi page 19

•
The yellow heating control lamp flashes up during the heating process and extinguishes after
the adjusted temperature has been reached. The fryer is equipped with a thermostat for
temperature regulation. Once the temperature in the oil container decreases the device
initiates the heating process and the green heating control lamp flashes up.
WARNING! Danger of burn!
During the work chips and oil in the oil container become very hot and there is a danger of
catching fire.
The device should not work for too long!
Set the knob of the temperature adjuster in the „O" position and unplug the device (take the
plug out of the socket!) as soon as the deep-frying process is finished and the device is not
being used.
•
For best results you should wait until the desired temperature has been reached before
placing the frying goods in the fryer.
•
The frying basket is designed for the preparation of small frying goods. It is equipped with a
fold-away handle and a hook.
•
Slowly set the frying basket into the frying oil. After frying carefully lift up the basket, hang it
into the fitting and let the oil drip off.
WARNING! Risk of injury!
The fryer may not be operated with the lid (cover)! The cover may be used for reasons of dust
protection or when keeping warm foods only. In order to avoid dangerous fat splashes caused
by water dripping from the cover you ought to make sure it is dry before setting it on top.
•
In case you accidentally engaged the dryer without having frying oil in the oil container or
without having inserted the minimum amount of fat, the device automatically shuts down at a
temperature of 230° C in order to protect itself fro m overheating. Whenever this occurs, switch
off the device, pull the power plug and let the device cool off.
After the device has been switched off by the heat
protection switch, it can only be restarted by pressing the
RESET-switch at the rear side of the fryer.
For this purpose, let the device cool down to a temperature
of 170° C and twist off the plastic screw cap coveri ng the
RESET-switch, press the RESET-switch push the cap
back onto the screw. Now you may reconnect the power
plug to the socket and engage the device to proceed as
normal.
The following food quantities should not be exceeded when frying:
•
Model 4 litres single fryer / 2 x 4 litres double fryer
•
Model 8 litres single fryer / 2 x 8 litres double fryer
- 20 -
All manuals and user guides at all-guides.com
Reset-switch
Micro-switch
0,6 kg each tank
0,9 kg each tank