Setting The Camera Output - Abus TVVR36000 Notice D'utilisation

Live view
Settings
Note
The live view can be set as follows.
Open the main menu, then click on "Configuration". Then
click on "Liveview":
The following settings are available in the TAB "General":
Video Output In- VGA/HDMI
terface
Select the connection where the set-
tings are changed
Different camera layouts
Live View Mode
1x1, 2x2, 1x5
Switching time between the individu-
Dwell Time
al cameras and the sequence dis-
play
Activate the au- Activates the audio output
dio (VGA/HDMI) for the live view.
Activate/deactivate the status bar
Display the status
bar
Allocate monitor for the output of
Event Output
events
in seconds, where the event on the
Full Screen Moni-
allocated monitor will be displayed.
toring Duration
in seconds, the duration of the Pop-
Post Event Dis-
up window when an event occurs.
play Time
NoteVGA monitor connected:
A connected VGA monitor automatically becomes
the main monitor where the audio output is also
assigned. The BNC output Video Spot Out output
displays the cameras in sequence and in full
screen.
No HDMI monitor connected:
If the HDMI cable is not connected to the monitor
at the start, the main video signal is emitted at the
Main VGA connection. Connect the VGA cable
and start the recorder again to perform the auto-
matic detection.
82
All manuals and user guides at all-guides.com

Setting the camera output

You can display a maximum of 4 cameras simultaneously
in the live view.
1.
2.
3.
4.
Click on the TAB "View".
Select the display mode.

1 x 1

2 x 2

1 x 5
The camera signal is assigned to the corresponding
image section using the navigation keys.

"X" means that this camera is not displayed.
Click on Apply to accept the settings.