Configuration
TAB General
Parameter
Setting
NIC Typ
Set the transmission speed of the in-
stalled network card here.
Tip: 10M/100/1000M self adaptive
Enable DHCP
Tick the box if the IP addresses are
assigned dynamically via DHCP in
the network.
DHCP activated: Subsequent entry
fields are inactive (parameters as-
signed via DHCP).
Note:
If the IP addresses are assigned
manually, ensure that DHCP is not
active (box not ticked).
IPv4 Adress
Address of the network device in the
network (manual assignment)
IPv4
Usually 255.255.255.0
Subnet Mask
IPv4 Default
Address of the gateway for Internet
Gateway
access
IPv6 address 1 Local (local link) IPv6 address
IPv6 address 2
Global (global unicatst) IPv6 address
IPv6 standard
IPv6 address of the gateway for In-
gateway
ternet access.
MAC Adress
Hardware address of the installed
network card
MTU (Bytes)
Describes the max. size of the largest
protocol data .
Preferred DNS
Address of the Domain Name Server
Server
(usually the IP address of the gate-
way)
Alternate DNS
IP address of the alternative DNS
server
Note
In certain modes some of these settings cannot be
selected.
All manuals and user guides at all-guides.com
PPPOE
1.
2.
DDNS
1.
2.
3.
Tick the PPPOE box, enter the user name (Internet
access ID) and password, then confirm the pass-
word.
Confirm the settings by pressing Apply.
Warning
Use PPPOE only if there is no router available.
To use the ABUS DDNS function, you must first set
up an account under www.abus-server.com. Please
note the FAQs on the website when doing this.
Tick the "Enable DDNS" box, enter 'ABUS DDNS' as
the "DDNS Type", then enter www.abus-server.com
or "62.153.88.107" under "Server Address".
Confirm the settings by pressing Apply. The IP ad-
dress of your Internet connection is now updated on
the server every minute.
90