Technical Data
Article number:
Model number:
Voltage supply:
Power:
Protection class:
Timer:
Temperature setting:
ID of operating instructions:
Troubleshooting
If the device does not work properly, first check whether you are able to rectify the
problem yourself. If the problem cannot be solved with the steps below, contact the cus-
tomer service department.
Do not attempt to repair an electrical device yourself!
Problem
The device does not
work. The displays on
the control panel do
not switch on.
The fuse in the elec-
trical distributor (fuse
box) is triggered.
During use, an
unpleasant smell is
detected.
08100_de-en-fr-nl_A5_V1.indb 21
21
08100
22912A0
220 – 240 V~ 50 / 60 Hz
max. 1600 W
I
up to 9 min 50 s
200°C – 850°C
Z 08100 M DS V1 1219
Possible cause
The mains plug is not
inserted correctly in the plug
socket.
The plug socket is defective. Try another plug socket.
There is no mains voltage.
The overheating protection
has been triggered.
Too many devices connect-
ed to the same circuit.
The device is dirty.
The device is being used for
the first time.
Fix
Push the mains plug into the
plug socket as far as it will go.
Check the fuse of the electrical
distributor (fuse box).
Pull out the mains plug and
allow the device to cool down
completely. Then try again.
Reduce the number of devices
in the circuit.
Follow the instructions in the
"Cleaning and Storage" chap-
ter.
A smell often develops when
new devices are first used.
The smell should disappear
once the device has been used
several times.
EN
18.12.2019 16:00:38