Menu Options - Luvion ICON DELUXE Manuel D'instructions

20

4. MENU OPTIONS

4.1.1 Adding cameras
The supplied camera is already paired with the monitor, there is no need to do this
again unless the connection is lost. Follow the steps below to pair an additional camera
with the monitor, or to pair the camera again:
Note: If the
already properly paired with the monitor on this channel. Pair a new camera on a camera
channel without the
1.
Press the menu / Ok button
Fig. 2)
2.
Use the , , , buttons to select the camera icon
3.
Press the menu / Ok button
nel to which you want to pair the camera with the
4.
Press the menu / Ok button
add camera icon
5.
Press the PAIR button on the back of the camera while the hourglass icon
displayed on the screen.
6.
If the pairing is successful, the
cessful, repeat the above steps.
4.1.2 Remove a camera
1.
Press the menu / Ok button
Fig. 2)
2.
Use the , , , buttons to select the camera icon
3.
Press the menu / Ok button
nel of which you want to remove the camera with the
4.
Press the menu / Ok button
remove camera icon
5.
Select the
6.
Press the menu / Ok button
4.2.1 Temperature unit setting
1.
Press the menu / Ok button
Fig. 2)
2.
Use the , , , buttons to select the temperature icon
3.
Press the menu / Ok button
4.
Select ˚C of ˚F with the
5.
Press the menu / Ok button
6.
Press the
Note: The temperature detection range is 0 ~ 40 ˚C.
4.2.2 Temperature alarm settings
1.
Use the , , , buttons to select the termperature alarm icon
temperature alarm. Press the menu / Ok button
2.
Use the , , , buttons to select the termperature alarm off icon
the temperature alarm. Press the menu / Ok button
4.2.3 Set temperature high and low warnings
1.
Select (red, high) or
maximum / minimum values for the temperature alarm.
symbol is displayed next to a camera channel, it means that a camera is
symbol.
on the monitor to display the menu on the screen. (see
to open the camera submenu. Select the camera chan-
to select the channel, use the , buttons to select the
, then press the menu / Ok button
icon appears on the screen. If the pairing is not suc-
on the monitor to display the menu on the screen. (see
to open the camera submenu. Select the camera chan-
to select the channel, use the , buttons to select the
then press the menu / Ok button
symbol with the , buttons to remove the camera.
to confi rm the selection.
on the monitor to display the menu on the screen. (see
to open the temperature setting submenu.
, buttons.
to confi rm the selection.
button to exit the menu.
(green, low) with the
in the menu.
, buttons.
in the menu.
, buttons.
in the menu.
to activate the
to confi rm.
to confi rm.
, buttons to set the temperature
is
to deactivate