Care & Maintenance - Luvion ICON DELUXE Manuel D'instructions

LUVION
TROUBLESHOOTING
Troubleshooting
No reception on the monitor
Poor range / Out of range or interference / The im-
age freezes / The resolution is poor
Audio problems
The battery does not last long enough
The monitor freezes / The image freezes /
The monitor stops responding
CARE & MAINTENANCE
•
Keep all parts and accessories out of the reach of children.
•
Fingerprints or dirt on the camera lens can adversely aff ect the image quality.
•
Avoid touching the lens with fi ngers.
•
Use a soft, non-static or slightly damp cloth to clean the baby monitor.
•
Keep the camera dry. Moisture can permanently damage the electronics. Never use the baby unit or parent unit in a
wet or damp environment.
•
Do not use or store in dusty or dirty areas.
•
Do not store in warm places. High temperatures can adversely aff ect the life of the electronics and aff ect the plastic
parts.
•
Do not store in very cold places. This can cause moisture to damage the electronics.
•
Leave the housing of the products closed. Opening the housing may damage the product and void the warranty.
•
Do not drop the product and avoid violent shocks.
•
Use this product only with the adapter that is supplied or is off ered as an accessory for this product. Connecting other
Premium Baby products
• The power adapters may not be connected
properly.
• Check if the camera and the monitor are on.
• The distance between the camera and the
monitor may be too large.
• The camera and monitor may not be paired
correctly. Pair the monitor with the camera
again.
• Move the monitor closer to the camera.
• The camera or monitor may be too close to
many metal objects.
• Other electronic devices interfere with the
signal.
• A WiFi network may interfere with the signal.
• The battery may have been drained
• Reduce the number of walls / fl oors / doors
between the camera and the monitor.
• If a loud beep is present (feedback beep),
increase the distance between the monitor
and the camera, or decrease the volume of the
monitor, press the down button
the volume.
•
Check if there is noise in the vicinity of the
camera.
• Make sure the volume is not turned off . Press
the up button
• Use the VOX mode, or connect the monitor to
the mains.
• Remove the adapter from the monitor and
replace it.
• Press the reset button on the back of the
monitor.
to decrease
to increase the volume.
23