Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points; How To Check That Your Canicom 300 Is Functioning Properly; Getting The Best Results - Num'axes CANICOM 300 Guide D'utilisation

Checking/Replacing battery of receiver collar


To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
• Battery fully charged: flashes slow green.
• Weak battery: flashes quickly red. Replace it with a new battery 3-V Lithium CR2 (See § Fitting the
battery in the receiver collar). Check the receiver collar operates correctly.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible with
your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.

Changing the contact points


Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).

How to check that your CANICOM 300 is functioning properly


You can check that your CANICOM 300 is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by screwing
them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the « F » or « C » button and modify the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.

Getting the best results


The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive and the range reaches approximately 300 meters (depending
on geography and environment).
The performances of your CANICOM 300 will be optimal if you respect the following
recommendations:
Gb - 27