Num'axes CANICOM 300 Guide D'utilisation page 25

Gb - 25
 F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent red while the stimulations are being sent.
 C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to
8 seconds maximum.
If you press the «C» button for more than 8 seconds, the collar will automatically go into safety mode for
a few seconds before restarting itself normally.
Nota: Beeps can be associated to the stimulation by pressing first the "C" button and then the
button.
 « Booster » button
Press the Booster button to stop your dog instantaneously. You can choose the stimulation level you
think to be the best for an immediate effect. As a result, you do not need to press the « + » button. Those
stimulations are transmitted by the two contact points located on the collar for as a long as the button
is pressed but no more than 8 seconds max.
If you press the « Booster » button for more than 8 seconds, the collar will automatically go into safety
mode for a few seconds before restarting itself normally.
« Booster » button configuration:
- select the stimulation level 01
- press the "-" button until the stimulation level flashes on the LCD screen
- press the "+" or "-" button to modify the stimulation level
- press the « Booster » button to confirm the level selected
 « + » and « - » : stimulation level control buttons
Use the "+"/"-" buttons for rapid adjustment of the stimulation level of the receiver collar.
12 levels are available.
Level 1: very weak stimulation. Level 12: strong stimulation.
Always start with the lowest level of stimulation.
 Retro-lightning of the LCD screen
( (
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/off switch ( )
(approx. 1/2 second).