Num'axes CANICOM 300 Guide D'utilisation page 23

- Activate: approach the area where the On/Off switch magnet is located inside the remote control until
coming in contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram 5),
the indicator light on the collar will flash in green indicating that the collar is On.
- Deactivate: approach the area where the On/Off switch magnet is located inside the remote control
until coming in contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram
5), the indicator light will flash from green to red and then off: the collar is off.
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are no
longer using your CANICOM 300 for a long period.
Diagram. 5
Activate/Deactivate a receiver
collar with a CANICOM 300
remote control
 Coding of the remote control and receiver collar
Each remote control has its individual radio operator code. The coding of the remote control with the
receiver collar enables to couple your remote control with the receiver provided.
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no other
person is using his CANICOM 300 or other products from the NUM'AXES range close by: your receiver
collar could accidentally record the code of his remote control. If that occurs, re-code the remote
control with the receiver collar.
Gb - 23
Approach until coming in
contact those 2 areas
during 1 second
COLLAR
REMOTE CONTROL