Operating Controls; Care And Maintenance; Technical Data - Weller WTBR 1000 Traduction De La Notice Originale

ENGLISH
EN

Operating controls

1 2
1
ON / OFF
2
Fault
3
Stop
4
Starts the process of the currently loaded WinControl program.
Start
After stopping, the machine starts the stopped movement in the
exact place where it was interrupted, provided machining has not
been ended via the operating interface.
5
Key-operated switch
You can use the key-operated switch to override the safety door
switches during setup
6
Power Activation of the power amplifier for axle control and control volta-
ge.
7
Emergency stop Abortion of all functions; the fault status can still be checked
using the software.

Care and maintenance

WARNING
Before doing any work on the machine, pull the plug out
of the socket. Leave the unit to cool down.
Daily
Soldering tip Check for wear
Replace if necessary
Cleaning station Beat the brushes
Empty the collection tank
Solder wire guide tube Check for wear
Replace if necessary
Weekly
Solder wire guide tube Clean
Replace if necessary
Every 3 months
Soldering tip Check the temperature
Heating element Replace if necessary
Solder wire feed system Visual check for wear on the drive wheels under
pressure or the drive shaft
Drive Check the switch point of the soldering end switch
Axles
Every 500-1000 operating Lubricate the axles (Ex works with sodium soap
hours grease GP00/000F-20 in accordance with DIN
5105022)
Every 100-200 operating If oil is used, relubricate.
hours
The operating hours can be displayed in WinControl.
Check all connected cables and hoses on a regular basis. If power tools are
damaged, they must be immediately removed from use.
Repairs and works specified in these Instructions may only be performed by qualified
authorised staff.
Use original replacement parts only.
20
All manuals and user guides at all-guides.com
3 4 5 6
Warranty
Claims by the buyer for physical defects are time-barred after a period of one
year from delivery to the buyer. This does not apply to claims by the buyer for
indemnification in accordance with §§ 478, 479 BGB (German Federal Law Gazette).
We shall only be liable for claims arising from a warranty furnished by us if the
quality or durability warranty has been furnished by use in writing and using the term
„Warranty".
7
The warranty shall be void if damage is due to improper use and if the device has
been tampered with by unauthorised persons.
For more information please visit
www.weller-tools.com.

Technical Data

Piston soldering robot / Soldering
machine
Dimensions L x W x H
Weight
Mains supply voltage
Power consumption
Compressed air connection
oil-free, dry compressed air
Work area
Positioning range
Soldering iron
Power consumption
Temperature range
Stroke Pneumatic module
Work angle
Solder wire feed system
Solder wire diameter
Speed
Power consumption
Planetary gear reduction
Stroke Pneumatic module
Work angle
Subject to technical alterations and amendments.
WTBR-1000
(mm) 1100 x 900 x 950
(inch)
(kg) 205
(V / Hz) 200-230 / 50-60
100-120 / 50-60
(W) max. 1500
bar 5,5 - 8
(mm) 390(2 x 195) x 205 x 100
(inch)
(mm) Axles:
x: 400
y: 300
z: 100
t: 270°
HER 120
(W) 120
(°C) 50 - 450
(mm) 50
-30° - +30°
(mm) 0,5 - 1,5
(mm /s) 0 - 24
(W) 1,7
1:166
(mm) 30
-30° - +30°