Operating Information; List Of Accessories; Scope Of Supply - Weller WFE P Mode D'emploi

Masquer les pouces Voir aussi pour WFE P:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
If the extraction performance of a cleaned FE soldering bit is
no longer adequate, the filters must be checked. The prelimi
nary filter can be changed several times before the main fil-
ter has to be replaced.
When original Weller filters are used in the prescribed man-
ner, the service lives of the particulate filter and the wide
band gas filter are designed to be approximately equal.
To change the filters, the two release buttons (3) for the lif-
ting device must be pressed simultaneously. The built-in lif-
ting device lifts up the pump casing (2) and exposes the
main filter cartridge (6). Following this, the main filter cartrid-
ge and the preliminary filter below it can be replaced without
the use of tools (see also exploded-view drawing).
Before the new main filter cartridge is fitted it should be
marked with the date of installation. The unit should be
installed in reverse sequence.
Warning:
When inserting filters, take care to follow the correct
sequence and fit them in the appropriate position. The
soiled filters must be treated as hazardous waste.

4. Operating information

The pump casing (2) simultaneously acts as a heat sink and
consequently heats up. Excessive heating is prevented by a
built-in thermal cut-out.
The WFE P soldering fume extraction unit is not suitable for
the extraction of flammable gases.

5. List of accessories

FE soldering iron for soldering fume extraction
005 25 153 99
FE 50 soldering iron 50 W
005 32 152 99
FE 50M Magnastat soldering iron 50 W
005 26 166 99
FE 75 soldering iron 80 W
005 26 162 99
FE 80 soldering iron 80 W
005 29 162 99
WSP 80 FE soldering iron 80 W
Supplementary parts
005 29 167 99
FE Accessory for WSP 80
005 29 177 99
WMP
005 25 125 99
FE Accessory for LR 21, LR 82, TCP S
005 13 125 99
FE Accessory for DS 22, DS 80, DSX 80
005 28 126 99
FE Accessory for WSF P5/8
005 36 352 99
Locking clip for FE soldering iron
005 25 410 00
Replacement hose for all FE soldering
irons (by the metre)
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

6. Scope of supply

The WFE P is equipped with:
1 fine particulate air filter F7
1 main filter cartridge consisting of Class H13 particulate
filter and gas filter:
50% activated carbon, 50% Puratex
1 mains cable
1 set of operating instructions
1 Safety Information
Illustration: exploded-view drawing - see page 42
Subject to technical alterations and amendments!
English
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wfe p2

Table des Matières