Blower Service Or Replacement (1101); Replacements - Napoleon EPI 1101 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.11

BLOWER SERVICE OR REPLACEMENT (1101)

Turn off all electrical power to the appliance. Remove the glass door and set aside
A.
in a safe place.
B.
Remove the top right side bricks from inside the firebox, 4-#7's and 2-#2's. Then
remove the rest of the side and back bricks from the right side of the appliance. It
is not necessary to remove the bottom bricks.
C.
The access panel can be removed by taking out the 8 #10 self taping screws. A
5/16" (8mm) nut driver will be required to complete this job. Unplug wires from the
thermal switch on the panel.
Remove the securing wing nut from the blower mounting bracket, slide the bracket
D.
to the right and rotate the left side of the assembly out of the cavity to clear the
blower motor. Disconnect the two wires from the blower motor.
Remove the ground wire from the blower mounting bracket,
then the assembly can be taken out of the rear cavity through
the access door opening.
Remove the 3 screws that hold the blower to the mounting
E.
bracket. Service or replace the blower as required.
Reinstall the blower assembly making sure the blower bracket
F.
is seated under the securing tab. Reattach the wire connectors.
G.
Replace the gasket on the access door. To replace the access
panel, reverse Step C.
H.
Replace the bricks into the firebox. Reinstall the door.

8.0 REPLACEMENTS

FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THIS MANUAL OR FAILURE TO USE
ONLY PARTS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
Contact your dealer for questions concerning prices and policies on replacement parts. Normally, all parts
** THIS IS A FAST ACTING THERMOCOUPLE. IT IS AN INTEGRAL SAFETY COMPONENT. REPLACE ONLY WITH
can be ordered through your Authorized dealer / distributor.
FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE WILL BE
REQUIRED TO HONOUR THE CLAIM.
When ordering replacement parts always give the following information:
Model & Serial Number of appliance
Installation date of appliance
Part number
Description of part
Finish
PARTS, PART NUMBERS AND AVAILABILITY ARE SUBJECT TO CHANGE WITHOUT NOTICE.
PARTS IDENTIFIED AS STOCKED WILL BE DELIVERED WITHIN 2 TO 5 BUSINESS DAYS FOR MOST
DELIVERY DESTINATIONS.
PARTS NOT IDENTIFIED AS STOCKED WILL BE DELIVERED WITHIN A 2 TO 4 WEEK PERIOD, FOR
MOST CASES.
PARTS IDENTIFIED AS 'SO' ARE SPECIAL ORDER AND CAN TAKE UP TO 90 DAYS FOR DELIVERY.
DAMAGE OR PERSONAL INJURY.
A FAST ACTING THERMOCOUPLE SUPPLIED BY WOLF STEEL LTD.
GROUND STUD
WARNING
!
27
GASKET
THERMAL
SWITCH
SECURING
TAB
WING NUT
WIRES
41.1C
W415-1469 / C / 08.20.18
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Epi 1402

Table des Matières