Other Connections; Connecting Auxiliary Components; Connecting An Analog Audio Component; Listening To An External Audio Source - Pioneer HTS-560DV Mode D'emploi

Other connections

Chapter 9
Other connections
Important
• When connecting this system or changing
connections, be sure to switch power off and
disconnect the power cord from the wall socket.
After completing all connections, connect the power
cord to the wall socket.
• Many of the buttons used extensively in this chapter
are used in conjuction with the SHIFT button.
The cursor buttons (
should all be used with SHIFT in the following
explanations.

Connecting auxiliary components

The receiver subwoofer has several digital inputs for
digital playback components, such as CD and MD
players.
CONTROL IN
MCACC
SETUP MIC
CONTROL SPEAKERS
SYSTEM CONNECTOR
OUT R L
SUB WOOFER SURROUND
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
CENTER R FRONT L
AC IN
CD recorder, etc.
• Connect the digital optical output jack on your
CD recorder, etc. to one of the DIGITAL optical input
jacks on the receiver subwoofer.
Use a commercially available optical cable to make this
connection.

Connecting an analog audio component

You can use the AUX input jacks to connect an analog
audio component, such as a tape player. See Using this
system for TV audio on page 13 for connection details
(this explains connecting the audio output from your TV,
but any analog audio component can be connected).
), ENTER and SR+
ANTENNA
FM AM
UNBAL 75Ω LOOP ANTENNA
AUDIO INPUT
DIGITAL ANALOG
DVD DTV PC/GAME AUX
(COAXIAL) (OPTICAL) (OPTICAL)
L
R
DIGITAL OUT
(OPTICAL)

Listening to an external audio source

You can connect both analog and digital external audio
sources to this system. Digital audio sources include
digital satellite receivers, CD recorders, etc. Analog
sources include your TV. See also Connecting auxiliary
components above.
DVD
DVD DTV
ENTER
1 If the system isn't already on, press
switch on.
Also make sure that the external source (TV, satellite
receiver, etc.) is switched on.
2 Select DVD, DTV, PC/GAME or AUX to select the
source for playback.
These buttons correspond with the input jacks on the
receiver subwoofer.
3 If necessary, start playback of the external source.

Connecting external antennas

For an external AM antenna, use 5–6 meters of vinyl-
insulated wire and set up either indoors or outdoors.
Leave the loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
15ft. to 18ft.
(5m to 6m)
RECEIVER
MUTE
VOLUME
PC/GAME AUX
TUNER
SR
SURROUND
ADVANCED
CLEAR
RECEIVER to
AM
LOOP ANTENNA
09
29
En