Specific Safety Rules - Dexter 2100AG2-230.5 Manuel D'instructions

shape for your selected wheel.
thus reducing the possibility of wheel breakage. Flanges for cut-o wheels
may be di erent from grinding wheel anges.
f) Do not use worn down wheels from larger power tools.
intended for larger power tool is not suitable for the higher speed of a
smaller tool and may burst.
Additional safety instructions for wire brushing operations
NOTE If wire brushing operation is not recommended by the manufacturer, this
section may be omitted.
Safety Warnings Specific for Wire Brushing Operations:
a) Be aware that wire bristles are thrown by the brush even during
ordinary operation.Do not overstress the wires by applying excessive
load to the brush.
and/or skin.
b) If the use of a guard is recommended for wire brushing, do not allow
anyinterference of the wire wheel or brush with the guard.
or brush mayexpand in diameter due to work load and centrifugal forces.

3. SPECIFIC SAFETY RULES

- Check that speed marked on the wheel is equal to or greater than the rated
speed of the grinder;
- Ensure that the wheel dimensions are compatible with the grinder;
- Abrasive wheels shall be stored and handled with care in accordance with
manufacturer's instructions;
- Inspect the grinding wheel before use, do not use chipped, cracked or otherwise
defective products;
- Ensure that mounted wheels and points are tted in accordance with the
manufacturer's instructions;
- Ensure that blotters are used when they are provided with the bonded abrasive
product and when they are required;
- Ensure that the abrasive product is correctly mounted and tightened before use
and run the tool at no-load for 30 s in a safe position, stop immediately if there
is considerable vibration or if other defects are detected. If this condition occurs,
check the machine to determine the cause;
Proper wheel anges support the wheel
The wirebristles can easily penetrate light clothing
180
Wheel
Wire wheel
FR
ES
PT
IT
EL
PL
UA
RO
EN