Dexter 2100AG2-230.5 Manuel D'instructions page 186

FR
To remove the protective cover, follow the installation procedure in reverse.
The protective cover can be turned to a desired angle, but not more than 45° on
ES
left side or right side.
PT
IT
EL
PL
UA
RO
EN
CAUTION:
Grinding and Surface Processing
In order to grind surface, you should use a coarse abrasive disk with a sunken
centre.
You can use the abrasive disks with diameter of 230mm. The maximum thickness
of disks is 6mm.
Mounting the Wheels /Disks
Please proceed as follows when mounting the wheel/disk
1. Before mounting, remove the mains plug from the socket! Ensure that the
protective device is correctly installed.
2. Place the internal ange (10) on the drive shaft (2). Ensure that it is in contact
with the two at areas.
3. Place the abrasive disks /wheels on the drive shaft (2). Ensure that it is
correctly in place.
4. Now screw the external ange (9) to the drive shaft (2), Ensure that it is facing
the right direction according to the di erent type of disk/wheel used. In the case
of abrasive disks, the ange (9) is inserted with the raised side towards the disk.
In the case of cutting-o wheels, the ange (9) is inserted with the at side
towards the wheels.
Please use Protective Cover (6) for grinding disc.
185