Intend Use - Dexter 2100AG2-230.5 Manuel D'instructions

FR
- Do not use separate reducing bushings or adapters to adapt large hole abrasive
wheels;
ES
- For tools intended to be tted with threaded hole wheel, ensure that the thread
in the wheel is long enough to accept the spindle length;
PT
- Check that the work piece is properly supported;
- Ensure that sparks resulting from use do not create a hazard e.g. do not hit
IT
persons, or ignite ammable substances;
- Ensure that ventilation openings are kept clear when working in dusty
EL
conditions. If it should become necessary to clear dust, rst disconnect the tool
from the mains supply (use non metallic objects) and avoid damaging internal
PL
parts;
- Always use eye and ear protection. Other personal protective equipment such as
UA
dust mask, gloves, helmet and apron should be worn;
- The wheel continues to rotate after the tool is switched o .
RO
- Never use the tool without the guard in place, the wheel guard must be tted
on the tool so that the closed side of the guard always points toward the
EN
operator.

4. INTEND USE

WARNING! Always wear protective goggles.
Observe the speci cations of the tool or accessory manufacturer! Protect the
discs from grease or impact!
Never use parting grinder discs for roughing work! Do not apply pressure to the
side of parting grinder discs.
The workpiece must lay at and be secured against slipping, e.g. using clamps.
Large workpieces must be su ciently supported.
If accessories with threaded inserts are used, the end of the spindle may not
touch the base of the hole on the sanding tool. Make sure that the thread in the
accessory is long enough to accommodate the full length of the spindle. The
thread in the accessory must match the thread on the spindle.
When working in dusty conditions, ensure that ventilation openings are not
blocked. If it becomes necessary to remove dust, rst up plug and avoid
damaging internal components.
Damaged, eccentric or vibrating tools must not be used.
Avoid damage to gas or water pipes, electrical cables and load-bearing walls
181