Additional Safety Warnings Specific For Abrasive Cutting-Off Operations - Dexter 20VAG2-125.1 Mode D'emploi

FR FR
2. SAFETY INSTRUCTIONS
ES ES
example: do not grind with the side of cut-off wheel. Abrasive
PT PT
cut-off wheels are intended for peripheral grinding, side forces applied
IT IT
to these wheels may cause them to shatter.
E. Always use undamaged wheel flanges that are of correct size
EL EL
and shape for your selected wheel. Proper wheel flanges support
the wheel thus reducing the possibility of wheel breakage. Flanges for
PL PL
cut-off wheels may be different from grinding wheel flanges.
F. Do not use worn down wheels from larger power tools. Wheel
RU RU
intended for larger power tool is not suitable for the higher speed of a
smaller tool and may burst.
KZ UA
Additional Safety Warnings Specific for Abrasive Cutting-Off
KZ UA
Operations:
RO RO
A. Do not "jam" the cut-off wheel or apply excessive pressure. Do
not attempt to make an excessive depth of cut. Overstressing the
BR BR
wheel increases the loading and susceptibility to twisting or binding of
the wheel in the cut and the possibility of kickback or wheel breakage.
EN
EN
B. Do not position your body in line with and behind the rotating
wheel. When the wheel, at the point of operation, is moving away
from your body, the possible kickback may propel the spinning wheel
and the power tool directly at you.
C. When wheel is binding or when interrupting a cut for any
reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the cut while the
wheel is in motion otherwise kickback may occur. Investigate and
take corrective action to eliminate the cause of wheel binding.
D. Do not restart the cutting operation in the workpiece. Let the
wheel reach full speed and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool is restarted in the
workpiece.
290