Dexter 2100AG2-230.5 Manuel D'instructions page 185

Overview
1. Switch button
2 .Guard locking lever
3. Auxi handle
4. Gear box
5. Main handle
6. Protective cover (grinding)
7. Lock button
8. Spanner
9. External flange with thread
10. Internal flange
11. Button for rotating handle
Mounting the Auxi Handle
The side handle (3) can be screwed in the hole on the left, right or top of the
gear box (4). Select the position which gives the most comfortable and safe use.
During operation, keep one hand on the rear handle (5) and the other on the
side handle (3).
Rotation of the Main handle
The rotation of the rear handle (5) makes the operation more comfortable.
Press the button (11) at the top of the rear handle to rotate 90° degree to the left
side or right side.
Installing or moving protective cover
Ensure the angle grinder is switch o and unplugged from the mains.
WARNING:
Depending on whether your operation is cutting or grinding, select the correct
protective cover. Failure to use the right cover for operation could result in injury.
When using a grinding or cutting-o wheel, the protective guard must be tted
on the tool so that the closed side of the cover always points toward the operator.
Install the guard: release the lock lever of the guard and insert it on the gear head,
and turn/adjust in any desired position for maximum performance, then close the
lock lever. Make sure that the fastening lever is properly locked after setting the
guard.
184
FR
ES
PT
IT
EL
PL
UA
RO
EN