Lubrication - Dexter 2100AG2-230.5 Manuel D'instructions

person (always replace the two brushes at the same time)
If the supply cord of this power tool is damaged, it must be replaced by a specially
prepared cord available through the service organization.
Cleaning
The tool and its air vents have to be kept clean. Regularly clean the tool's air
vents or whenever the vents start to become obstructed.
Avoid using solvents when cleaning plastic parts. Most plastic parts are
susceptible to damage from various types of commercial solvents and may be
damaged by their use. Use clean clothes to remove dirt, carbon dust, etc.

Lubrication

All the bearings in this tool are lubricated with a su cient amount of high
grade lubricant for the life of the unit under normal operating conditions,
therefore no further lubrication if required.
Storage
Store the angle grinder in a dry place. Regularly inspect the disks / wheels,
ensure that the disks / wheels is free of cracks and surface defects. Replace the
disks / wheels when it has wore out.
Take care not to expose this tool to the rain.
10. TRACEABILITY NUMBER /
SERIAL NUMBER
The Traceability Number/Serial Number will be showed in the label.
11. TROUBLESHOOTING
PROBLEM CAUSE
Machine does 1.Power cord not plugged in.
not start. 2.Power cord is damaged.
3.Circuit breaker is tripped.
4.Switch is locked at "OFF"
conditions.
SOLUTION
1. Plug in cord.
2. Replaced at authorized
service center.
3. Reset circuit breaker.
4. Restart the tool.
188
FR
ES
PT
IT
EL
PL
UA
RO
EN