Dexter 2100AG2-230.5 Manuel D'instructions page 190

FR
Motor does
not reach full.
ES
PT
IT
Motor stalls,
blows fuses,
EL
or trips circuit
breakers.
PL
UA
Motor
RO
overheats.
EN
Machine
vibrates
or shakes.
12. GUARANTEE
DEXTER products are designed based on the mostrigorous quality standards for
products intended for the general public.
The Angle Grinder (Model n° 2100AG2-230.5) is covered with a warranty of 3
years. starting from the date of purchase. This warranty covers all
manufacturing or material defects.
In the event of a breakdown, please refer rst to the troubleshooting page
(problems and solutions)in the brochure; if the problem persists, please check
1. Voltage from power
source.
2. Circuit is overloaded.
3. Motor burned out.
1. Switch is defective.
2. Carbon brush is wornout.
3. Voltage from source is
low.
4. Fuses or circuit breakers
are wrong size or defective.
1. Motor is overloaded.
2. Grinding disc is being fed
into work too fast.
3. Air vents become
obstructed.
1. Disc is out-of-round.
2. Disc is chipped.
3. Disc is loose.
4. Machine is not secure.
5. Work surface is uneven.
1. Request a voltage check.
2. Test on a di erent circuit or
without anything else on circuit.
3. Have tool serviced and
request a voltage check.
1. Replaced at authorized
service center.
2. Replace at authorized
service center.
3. Request a voltage check.
4. Replace with a correct
circuit breaker or fuses.
1. Request a voltage check.
2. Feed grinding into work
slower.
3. Clean air vents.
1. Replace wheel.
2. Replace wheel.
3. Set ange nut correct and
tighten it.
4. Check machine and all
hardware.
5. Feed grinding into work
slowly.
189