Jenn-Air JES9800CAS Instructions D'installation page 15

Style 2: Direct wire strain relief
Use Phillips screwdriver to remove screws from panel on
back of range.
Lift range back panel up and off.
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
Position cord/conduit plate as shown in the following
illustration.
USE USE
REMOV REMOV E TAG! POWER E TAG! POWER POWER TA CORD S CORD CORD TA
NUTS NUTS NUTS WITH QUITE WITH QUITE WITH LA LAS LA TAR ETIQUE TAR TUERCA ETIQUE ICO ICO EL EL
USE PARA PARA CONEC CONEC N ELÉCTR N ELÉCTR
CORDÓ CORDÓ
E TAG! E TAG! POWER POWER POWER CORD CORD TA USE CORD TA USE
NUTS NUTS NUTS WITH QUITE WITH REMOV QUITE WITH REMOV LA LAS LA ETIQUE TAR TUERCA TAR ETIQUE ICO ICO EL EL S
PARA PARA USE CONEC CONEC N ELÉCTR N ELÉCTR
CORDÓ CORDÓ
Replace cord/conduit plate and insert screws.
Assemble a UL listed conduit connector in the opening.
A. Removable retaining nut
B. Strain relief
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
A
B
15