Jenn-Air JES9800CAS Instructions D'installation page 12

6. Connect vent system to blower motor outlet (option 1 shown)
with 4 - #8 x ¾" hex head screws provided.
A
B
C
A. Inlet
B. Vent clamp
C. Floor
D. Vent system
7. Go to the "Electrical Connection" section.
Left or Right Side Venting
1. Mark cabinet side for either a left or right side vent hole
location.
A
B
³⁄₁₆
A. 31 " (79.2 cm) to top of cabinet
B. 18" (45.7 cm) from back wall
2. Mark and cut a 5½" (13.9 cm) diameter hole in the desired
cabinet side.
A. 5½" (13.9 cm) diameter hole
12
D
A
3. Mark and cut a 14" x 11" (35.6 x 27.9 cm) opening in the floor
of the same cabinet as the vent hole opening.
A
B
A. 11" (27.9 cm) from front of cabinet
B. 14" (35.6 cm) from left side of cabinet
4. Remove 4 locknuts on the motor side of the blower and
remove the bracket.
View from Motor Side of Blower
A
A.Electrical connector
5. Lift and rotate the motor 180° to reposition the electrical
connection.
A. Electrical connector
6. Rotate bracket 180° and secure with 4 locknuts.
Top View
A