Bestway 58515 Manuel Du Propriétaire page 14

TROUBLESHOOTING
Problems
- Sand is too small
- Move the control valve from
Sand is flowing
to the pool
- The level of the sand is too high
- The skimmer is broken
- Stopper plugs were not removed
- Air was not released
- The control valve is set to Closed
No water flow
- The strainer is blocked
- Sand filter broken
- Dirty filter
- Calcified sand bed
Excessive filter
- Insufficient backwashing
pressure
- The pressure gauge is broken
Control Valve
- Control Valve is set between two
leaks from the
port D
- The gasket is broken
- Washer of the connectors not in
- Washer of the connectors broken
Connectors leak
- O-ring on the hose connection is
- Loose Hoses
Probable Causes
the backwash to the filter
function without stop the sand filter
functions
place
broken
- Recommend 0.45 mm to 0.85 mm #20
silica sand
- Stop the sand filter every time set the
control valve
- Check if the level of the sand is
between the marked "MAX" and " MIN"
on the collector hub
- Replace the skimmer
- Remove the stopper plugs and
insert the debris screens
- Release the air
- Set to filter function
- Clean the strainer
- Call for service
- Backwash
- Inspect sand and change if
necessary
- Backwash until water runs clear
- Replace the pressure gauge
- Set to one function
- Replace the gasket
- Reposition the washer
- Replace the washer
- Replace the O-ring
- Tighten them
14
Solutions