Bestway 58515 Manuel Du Propriétaire page 8

level ground, preferably a concrete slab. Position the sand filter
so the Ports and Control Valve are accessible for operation,
servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be
vertically fixed on ground or a certain pedestal made of wood or
concrete before use to prevent the sand filter from accidentally
falling. Fully assembled sand filter will exceed 18 kg. The
mounting holes should be 8 mm in diameter and spaced 285
mm apart. Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay:
#20 Silica sand 0.45-0.85 mm, approximately one 8.5 kg bag should
suffice. If you do not use the recommended size filter sand, filtering
performance will be reduced and the sand filter may damaged, thereby
voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some
water into the Bottom Tank to submerse the Skimmer on the Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
CONNECT TO THE POOL
For 38 mm(1.5 in)
connection
C
C
8
MAX.
MIN.
C
C