Bestway 58515 Manuel Du Propriétaire page 11

Drain:
This function drains water
from the pool; another filter bypass
setting, water is pumped and deposited
out of Port D, instead of returning it to
the pool.
A
NOTE:
• Be sure all provisions for wastewater disposal meet applicable local, state or
national codes. Do not discharge water where it will cause flooding or damage.
• When the Control Valve is set to the Backwash, Rinse, or Drain position, water
will discharge from Port D on the Control Valve.
• Do not switch on or operate the sand filter with the Control Valve set to the
Closed function or it will seriously damage the sand filter.
• Do not set the Control Valve between two functions, or it will lead to leaking.
• To avoid water leakage, screw the Port D Cap onto the Control Valve Port D
before operating the sand filter.
AIR RELEASE
Press down the control valve handle and wait untill the water flow
from Port D to release the air.
NOTE: It is important to repeat this operation every time you start
the pump after winterizing, maintenance and backwashing the sand
bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the pump for its first use and to wash
the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs clear.
3. Switch off the sand filter and set the Control Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for
1 min. This circulates water backwards through the
sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the
Closed function.
C
D
C
B
Circulate:
pool water bypassing the sand filter; use
this function if the filter is broken to
collect debris in the Debris Screens.
Backwash
11
This function circulates
C
A
D
C
B
Rinsing