EUROM PSOK 2000 Manuel D'utilisation page 28

flames. Check regularly to ensure that the surface is not
overheating; this could be dangerous!
8. Never place the device on surfaces such as beds or deep-pile carpet
as openings could be blocked.
9. Do not place the device near an open window as rain could blow in;
do not place on wet surfaces and avoid any liquids being spilt
nearby. Do not place the device behind a door or along a walking
route to avoid accidental trips.
10. Do not place the device near, under or facing an electrical socket
and not in the vicinity of an open fire or heat source.
11. Do not use the device nearby or facing furniture, curtains, paper,
clothing, bedding or other flammable materials. Keep at least 1
metre from device!
12. Do not use the heater outdoors or in areas that are smaller than
20m³.
13. The device contains hot and/or glowing and sparking components.
Do not, therefore, use where fuels, paint, flammable fluids and/or
gases are stored. Do not use the device in an environment that
poses a fire risk, e.g. near gas tanks, gas pipes or aerosols. This is
an explosion and fire risk!
Warnings - use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
3. Some parts of this device will get very hot and could cause
burns. You must pay particular attention to children,
vulnerable persons and pets that are present near the
device. Never leave them alone with a working device.
4. Never cover or block the device; it will overheat and this could lead
to a fire risk. Never hang or place objects such as clothing,
blankets, cushions, paper, etc. on the device.
The minimum distance of 1 metre between the device and
flammable materials must always be applied.
Ventilation openings should never be blocked as this may pose a
fire risk. Never use the device to dry clothing or place anything on
it. Do not let anything lean against the device!
5. Do not set the device to come on automatically using a timer, clock
or other facility. You must always check for safe conditions before
28