De Dietrich DTE410 Guide D'installation Et D'utilisation page 28

All manuals and user guides at all-guides.com
99632084_ML_A.qxd 20/01/05
1 1 / / INSTALLING YOUR APPLIANCE
•
Gas supplied by tank or cylinder
(butane/propane)
For your safety, you must choose from the
three following connection options:
— Connection with a rigid pipe made from
copper and with screw-on mechanical
connectors (G1/2 gas standard mark). Make
the connection directly to the end of the
elbow fitted on the appliance
— Connection with a wavy metal hose
(stainless steel) with screw-on mechanical
connectors (compliant with NF D 36-125
standard) whose service life is unlimited
(Fig. 01).
— Connection with a reinforced rubber hose
with screw-on mechanical connectors
(compliant with the XP D 36-112 standard)
whose service life is 10 years (Fig. 02).
A
Sealing washer
B
Adaptor (not supplied)
C Clamp (not provided)
13:30 Page 28
In an existing system, a soft pipe fitted with
clamps whose service (compliant with the XP
D 36-110 standard) whose service life is five
years may be used. It is necessary in this case
to use an adaptor without forgetting to fit a
sealing washer between the adaptor and the
hob's elbow (Fig. 03).
Tip
You can obtain the adaptor and the sealer
washer from your After-Sales Service
Department.
Warning
Screw on the adaptor with a torque
not to exceed 25 N.m.
Fig. 01 Fig. 02
Warning
All soft pipes and hoses whose
service life is limited must have a maximum
length of two meters and must be
accessible along their entire length. They
must be replaced before the end of their
service life (indicated on the pipe).
Regardless of the means of connection
chosen, ensure that the connection is air
tight, after installation, with soapy water.
In France, you must use a hose or a pipe
bearing the stamp NF Gaz
28
Fig. 03
A
B
C
GAZ