Turning On The Appliance - Saba LVIF1020DD1542G Mode D'emploi

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket
first, then the upper one (see the section entitled «Loading the
Dishwasher»). Pour in the detergent (see the section entitled
«Salt, Detergent and Rinse Aid»).
2. Insert the plug into the socket. The power supply is 220-240V AC
50 Hz, the specification of the socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure.
Close the door, press the «Power»button, Press the «Program»
GB
button to select a desired «Wash cycle». (See the section entitled
«Wash Cycle Table») . With a little force to ensure the door is
properly closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing
«Power» button.
Change the Programme.
Premise: A cycle that is underway can only be modified if it has
only been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled « Fill in the
Detergent « ).
94