Saba LVIF1020DD1542G Mode D'emploi page 79

Attention!
Clean up any rinse aid split during filling with an absorbent cloth
to avoid excess foaming during the next wash.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four or
3
4
six settings. Always Start with the
2
5
1
dispenser set on «4» If spots and
6
poor drying are problems, increase
the amount of rinse aid dispensed by
MAX
removing the dispenser lid and rotating
the dial to «5». If the dishes still are not
GB
Adjust lever (Rinse)
drying properly or are spotted, adjust
the dial to the next higher number until your dishes are spot-free.
The dose is factory set in position 5.
NOTE: Increase the dose if there are drops of water or lime spots
on the dishes after washing. Reduce it if there are sticky whitish
streaks on the dishes or a bluish film on glassware or knife
blades.
D. Function of Detergent
Detergents with its chemical ingredients are necessary to remove
dirt, crush dirt and transport it out of the dishwasher. Most of
commercial quality detergents are suitable for this purpose.
78