Saey CROSS Notice D'installation Et D'utilisation page 65

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

This control allows you to regulate the amount of air required by the stove to ensure combustion. This
control works with different positions. If the control is to the right (+), the air supply is fully open. If it
is to the left (-), it is closed. You can also set the position in the middle, so that the control is half-open.
Combustion air completely closed,
handle on the far left
Making fire
Make sure that the air supply is to the right
-
If necessary, first clean the ash tray and combustion chamber
-
Place logs of wood in the stove
-
On top of that put some kindling, disperse them and light it.
-
When lighting the fire, leave the door a little open for a few minutes.
-
When you a good fire, close the door firmly with the control handle
-
Use heat-resistant gloves !
Continuing to burn
To refill the stove with wood, please re-open the air control lever to the right. You may refill wood
through the filling door on the side, as long as there are no more flames visible. Always open the door
in a gentle manner.
If necessary you can keep the filling door open for a little while until the flames flare up. After 3 minutes,
seal off the door firmly and adjust the air control a little to the middle. The nominal position is now
between the maximum right position and point zero in the middle.
Normally a full load of wood allows you to burn for over 60 minutes, as long as it meets the right
quantity and burning parameters.
Avoid to fill your stove with too much wood, as in this way you will overheat your stove and it will have
a detriment effect on the life expectancy of your stove. Please respect all maximum quantities as
prescribed in chapter 2 of this manual.
Combustion air completely open,
handle on the far right
65

Publicité

Table des Matières
loading

Table des Matières