Saey CROSS Notice D'installation Et D'utilisation page 57

Flue gas outlet connection
The flue gas connection can optionally be mounted on the cover plate (top outlet) or in the rear wall
(rear outlet). On delivery, the connection piece is already fitted into the back wall, the top outlet is
closed off with a blind cover.
The outlet that is not used must be closed with an outlet cover.
Preparation for rear outlet
Break out the cutout at the top for the
connection of the rear panel joint
(move the pre-cutout slightly back and forth)
The rear panel can also be removed for
this purpose - 6 screws, M6 x 8mm,
cross-head screws
Preparation of the upper outlet
Dismantle the rear panel,
6 screws M6 x 8 mm, cross-head screws
Loosen and remove the blind cover in the
cover plate, loosen the screw through the
rear outlet, fix crossbar with
1 hexagonal screw
Loosen and remove the rear cast iron
connecting piece, loosen the screws through
the upper opening in the cover plate -
2 hexagonal screws M6 x 16 mm, SW 10
57