Burkert 3005 Mode D'emploi page 25

control signal when current 0 ... 20 ma
→
Press <MEM> and <OPEN> push-
buttons and switch on the card (hold
down push-button).
The RED LED lights up 3x.
R
→
Release <MEM> and <OPEN> push-
buttons and disconnect the card from
the power supply.
control signal when current 4 ... 20 ma (preset)
→
The RED LED lights up 3x.
R
→
Type 3005
Installation
Press <MEM> and <CLOSE>
push-buttons and switch on the card
(hold down push-button).
Release <MEM> and <CLOSE>
push-buttons and disconnect the
card from the power supply.
learning mode
specify end positions
→
The RED and the GREEN LED's light
up.
G R
→
Both LED's go out.
Learning mode is selected.
→
R
The RED LED lights up.
→
R
The RED LED lights up 2x.
→
G
The GREEN LED lights up.
english
Press <OPEN> and <CLOSE>
push-buttons and switch on the
card (hold down push-button).
Release <OPEN> and <CLOSE>
push-buttons.
Press <CLOSE> push-button to
move the shut-off valve into the
closed position.
Press <MEM> and <CLOSE>
push-buttons to save the closed
position.
Press <OPEN> push-button to
move the shut-off valve into the
open position.
25