Setting Up; 1- Connecting The Telephone - Geemarc AmpliPOWER 40 Mode D'emploi

Setting up

1 – Connecting the telephone
- Connect the handset cord (1).
- Unclip the battery door with a screw driver in the hole. Insert
4 x AAA alkaline batteries (not included) (2). In case of
power failure, batteries are required for the ring.
- Snap the battery door back in place.
- Connect the line cord (*) (3).
- Connect the shaker cord (optional).
- Connect the headset cord (optional).
- Connect the PTT plug to the wall socket (*) (3)
- Connect the adaptor cord to the telephone (4).
- Connect the adaptor to you wall socket (**)(4).
(*) Classified TNV-3 according to EN62368-1 standard.
(**) Classified "hazardous voltage" according to EN62368-1 standard.
2 – Alarm and ringer volume setting
A 3 position switch located on the right side of the phone allows
the settings below:
0 : Only the ringer is activated.
: Ringer and shaker are activated.
: Ringer and flash LED are activated.
5