Installation; Setting Up; Wall Mounting - Geemarc PhotoPHONE 100 Mode D'emploi

INSTALLATION

Setting Up

Connect the handset to one end of the curly cord. Plug the other
end of the curly cord into the jack on the left hand side of the
PHOTOPHONE 100 unit. Place the handset on the cradle.
Connect the line cord to the jack located at rear of telephone then
connect the plug at the other end of the line cord into the wall
socket *.
(*) Classified TNV-3 according to EN60950 standard

Wall Mounting

Slide the handset hanger tab out and reverse its position (rotate it
180 degrees). Slide it back into place so that the hook points up
(see diagram 1). This will keep the handset from falling out of the
cradle when it is mounted on the wall.
Install two self-tapping screws (not supplied) at a distance of 80
mm from each other and located on a vertical line.
Place the phone onto the screw-heads and slide down to secure
(see diagram 2).
Turn the hook in the receiver cradle so that the receiver can be
placed on-hook.
Diagram 2
Diagram 1
6