3- Ringer Settings; 4- Tone/Pulse Switch (T/P); 5- Time Break Recall Setting (300/100) - Geemarc AmpliPOWER 40 Mode D'emploi

3 – Ringer settings
A switch located on right side allows the ringer to be switched
HI, LOW, OFF :
: Off,
Your phone comes with the ringer switched to «High» and the
melody set to «6».
Melody 1
Melody 2
Melody 3
If you don't like the ringer melody,you can choose a new one
by changing the settings as follow:
- Lift the handset.
- Press
- Press # button.
- Press any button 1 to 9.
Ringer will be activated on next call.
4 –Tone/Pulse switch (T/P)
The Tone/Pulse switch is factory pre-set to Tone position. In
the UK, all telephone exchanges now use Tone (T) dialing. If
your phone does not dial out, it is probably being used from an
older private switch board (PBX). In this case, the Tone/Pulse
switch must be changed to Pulse (P).
5 – Time Break Recall setting (300/100)
For the UK, the TBR switch is factory pre-set to 100ms. It can
be switched to 300ms for other locations or PBX's.
: Low,
Low
1
4
7
utton.
: Hi.
Mid High
2 3
5 6 (by default)
8 9
6
Setting up