Options; 16- Direct Vibe Handset; 18- Headset With Microphone - Geemarc AmpliPOWER 40 Mode D'emploi

To register your stored phones numbers, use the index located
under the base.
16 – Direct vibe handset (optional)
If you have conductive hearing loss you can use a Direct Vibe
Handset, try placing the Direct Vibe handset on your telephone,
in front and slightly below your ear or behind your ear to see
which position works best for you.
If you require a Direct Vibe Handset ref: CLA4 you may purchase
it from your retailer or audiologist.
In case of difficulty please visit our website www.geemarc.com
To set up the Direct Vibe handset, disconnect the standard
handset from the curly cord, then replace it with the Direct Vibe
handset.
17 – Shaker (optional)
If you wish to compliment your phone by using a SHAKER ref:
CLA2 connect the shaker plug in the socket
the back edge of the telephone. When an incoming call is
received, the shaker will be activated when the phone rings.
Note : This option must be set in the ALARM AND RINGER
OPTIONS item (page 5) to be activated. To purchase a SHAKER
see item 1 above.
18 – Headset with microphone (optional)
If you wish to answer or make calls by using a Geemarc headset
ref: CLA3, connect the headset plug in the headset socket
located over the back edge of the telephone.
Note: When using a headset, the speaker will be activated and
it's recommended to adjust the speaker to the low position.
12

Options

located over