Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld Ecoline Série Mode D'emploi

Manual: Ecoline Series EL-200G KeyTEX

1. Product and package contents

Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser projector
1 x external PSU
1 x USB extension cable

2. Preliminary warning notices

1. Please use this device only according to these operating instructions.
2. Do not use the device if there are any visible damages on housing, connector panels,
power supplies or power cords.
3. Never look directly into the light source of a laser projector. Danger of damage to the
eyes or even blindness in extreme circumstances!
4. Do not operate the device at high humidity, in the rain or in dusty environments.
5. Protect device against dripping or splashing water. Do not place any liquid filled
containers near to this device.
Any warranty claims are void if the warranty label is removed or tampered

3. Initial operations, safety instructions

1. Make sure to use correct voltage; see in-
formation on device & in this manual.
2. Make sure that the device is not connec-
ted to mains during installation.
3. Installation has to be done by technical
experienced and qualified persons ac-
cording to safety regulations of the res-
pective country.
4. Always ensure that maximum permis-
sible exposure (MPE) is not exceeded
in areas accessible to the public.
5. In some countries an additional
pection by technical control institutes
could be necessary.
6. Connect an easily accessible inter-
lock connector or circuit breaker
to the projector.
page 4 / 32
1 x USB keyboard
1 x USB to PS/2 adapter
1 x Interlock connector
with in any way.
7. The power supply should be easily acces-
8. If the device has been exposed to great
9. Never use dimmer, RC or other electroni-
ins-
10. Ensure sufficient ventilation and do not
1 x IR remote
1 x user manual
sible.
temperature changes, do not switch it
on immediately. Condensation (or any
moisture/water formed) may damage
device.
cally switched sockets. Whenever possib-
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
place the device on any warm or heat ra-
diating surface. Especially the ventilati-
on openings must not be covered!