Speedlink Erazor RF Pad Mode D'emploi page 14

Signal LED (green):
D
When on or flickering data is being transmitted
GB
between controller and receiver.
Mode LED (red)
F
The Mode LED is on for analog mode and off
E
for digital mode. Press the analog button (see
illustration) to change the mode.
I
Analog button:
Press the analog button to select the digital
mode. Press the analog button again to get
back to the digital mode.
Important Safety Information
Do not attempt to service or repair the device
yourself. Refer all servicing to qualified service
personnel.
Do not attempt to modify the device in any way.
Doing so could invalidate your warranty.
Do not use this apparatus near water (for
example, sinks, baths, pools) or expose it to rain,
moisture, or dripping or splashing liquids.
14
All manuals and user guides at all-guides.com