Using The Shark Ion™ Robot; Buttons And Indicator Lights; Installing The Side Brushes - shark ion RV850C Série Guide D'utilisation

USING THE SHARK ION™ ROBOT

BUTTONS AND INDICATOR LIGHTS

s h a r kc l e a n . c o m
CLEAN BUTTON
Press to begin a long-
running cleaning session.
Press again to stop.
DOCK BUTTON
Press to stop cleaning
and send robot back
to the charging dock.
MAX MODE BUTTON
Press to begin a
powerful cleaning.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
Blue light: connected to
Wi-Fi.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
Red light: not connected.
section of the floor to ensure there is no scratching.
Flashing blue: setup mode.
IMPORTANT: Robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when they
are dirty. For best results, clean sensors regularly.
No light: not set up yet.
TIP: To preserve battery life, turn off the power switch if robot will not be used for a long period of time.
TIP: To preserve battery life, unit should be recharged at least once every three months.
USING THE SHARK ION™ ROBOT

INSTALLING THE SIDE BRUSHES

The 2 included side brushes snap onto the square
pegs on the bottom of the robot. Press brushes
down onto the pegs until they click into place.
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the Clean
button on the robot or on the mobile app. To stop
the robot before it finishes cleaning and automatically
returns to the dock, press the button again.
s h a r kc l e a n . c o m