Botboundary™ Strips; Emptying The Dust Bin - shark ion RV850C Série Guide D'utilisation

Table des Matières

Les langues disponibles

USING THE SHARK ION™ ROBOT

BotBoundary™ strips

To keep your robot away from certain areas, such as pet bowls, fragile objects, power strips,

or doorways, use the BotBoundary strips to quickly and easily create "no-go zones".

BotBoundary strips

Identify areas or objects you want the robot to avoid.

4-inch

Min.

For your robot's cliff sensors to work properly,

all runners, rugs, or carpets must be at least

4 inches from any stairs (or extend over the edge

of the stairs.)

If a runner, rug, or carpet edge is less than

4 inches from the stairs and can't be moved,

use a BotBoundary strip to block off the stairs.

NOTE: To prevent bumping, place strips at least 2 inches in front of the object you want to block off.

NOTE: You do not need to use BotBoundary strips on stairs. Your robot has cliff sensors that will prevent it from falling

off any ledges or stairs.

s h a r kc l e a n . c o m

Cut the BotBoundary strip to the desired length

(18˝/45cm minimum) so that it spans the length

of the doorway or object you want to block off.

For best results, make sure your BotBoundary strip

is completely flat against the floor. Make a closed

loop around an object, or place the strips between

fixed objects, like door frames or the legs of a couch,

to create no-go zones.

MAINTENANCE

CAUTION: Turn off power before performing any maintenance.

EMPTY DUST BIN AFTER EACH USE.

Press the dust bin removal button and slide out the

dust bin.

Empty debris and dust into trash.

To open the dust bin lid, press and hold the button

while lifting the lid, using the finger slots.

s h a r kc l e a n . c o m

Table des Matières