Using Steam; Using The Steam Energized ™ Cleanser - shark SK410 Série Manuel Du Propriétaire

fig. 10

Using Steam:

1 Turn the steam locking collar to the "Steam &
Spray" position. (Fig. 9)
2 Wait 30 seconds for the boiler to heat the water.
Pump the handle a few times to prime the pump,
activate steam and moisten the cleaning pad.
(Fig. 10)
3 Clean your floors with a forward and backward
motion to customize steam output automatically.
(Fig. 11)
WARNING: Never stand on the Steam & Spray
Mop.
4 When the water tank is empty, the steam mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the electrical outlet. Follow instructions on page 4.
IMPORTANT: The Steam & Spray Mop
plugged in to use the steam function.
Steam
&
Spray
fig. 9
fig. 11
must be
™
fig. 12
fig. 13
Using the Steam Energized
1 Make sure that the batteries are inserted into the
battery compartment behind the Cleanser Bottle to
use the spray function. See page 3.
2
Press the Spray Button to apply solution onto the
floor that is to be cleaned. (Fig. 12, Fig. 13)
3 If the Cleanser Bottle is empty, you can replace it at
any time as long as the unit is unplugged from the
electrical outlet.
IMPORTANT: Never leave the Steam & Spray
™
Mop with a damp/wet cleaning pad on any floor
surface for any amount of time as this may damage
the floor.
4
Once finished, step on the tab of the cleaning pad
and lift the unit to remove the cleaning pad.
NOTE: If you wish to use the Steam Energized
Cleanser without steam, turn the steam locking
collar to the "Spray Only" position. This will
prevent the handle from pumping and activating
the pump. (Fig. 14)
Spray
Only
fig. 14
Cleanser:
™
www.sharkclean.com
™
™
5