Water Drainage - Danby DPA080C2SDB Guide D'utilisation Et D'entretien

Operating Instructions

WATER DRAINAGE

1. Drain access water from the tank by placing a pan under the drain water
outlet (Fig. 4).
2. Remove the drain plug and let the water drain into the pan.
3. When the water stops draining out, replace the drain plug.
4. Remove the pan of water.
5. Operate the unit in Fan mode to dry the interior of the unit.
When using the drain function, the PVC hose must be placed horizontally below the drainage hole. Avoid uneven ground
and folding the hose.
Note: Should you damage or misplace the PVC drain hose, a standard garden hose can be used.
1. Remove the plug at the drainage port. (Fig. 1)
2. Fix the drainage pipe clip on the right of the rear side plate near the drainage port with a screw. (Fig. 2)
3. Put the drainage pipe into the drainage port and screw it in. Place the drainage hose over a fl oor drain.
4. When you are not using the continuous drain function, put the rubber plug into the other side of the drainage pipe, fi x
it with the pipe hoop and then the drainage pipe clip. (Fig. 3)
Fig. 1
Plug
Drain Port
Fig. 3
Pipe Hoop
Drainage Pipe
Drainage Port
Fig. 2
Drain Port
Pipe Hoop
Plug
Drainage Pipe
Clip
14
Fig. 4
The back of the unit.
Drainage Pipe
Clip
Screw