Care And Maintenance - Danby DPA080C2SDB Guide D'utilisation Et D'entretien

Care and Maintenance

1. Be sure to unplug the unit before cleaning or servicing.
2. Do not use gasoline, paint thinner or other chemicals to clean the
3. Do not wash the unit directly under a tap or using a hose. It may
4. If the power cord is damaged, contact the service depot immediately.
AIR FILTER
Clean the air fi lter at least once every two weeks. Accumulation of dust will hinder fan operation.
REMOVAL
To remove the air fi lter, pull the air fi lter out in the direction of the arrow and remove the fi lter.
This unit has two fi lters. Lift the upper fl iter out in the direction of the arrow (Fig. 25), then down. Remove the
lower fi lter by loosening the screw and lifi ng out the fi lter as shown in Fig. 25.
CLEANING
1. Wash the air fi lter by submerging it gently in warm water (about 40°C / 104° F) with a neutral detergent.
2. Rinse the fi lter and let it dry.
REINSTALL
Install the upper air fi lter after cleaning, and install the lower fi lter after, using the screw (see Fig. 26). *Filters
Replace the air fi lter and cover. *Filters should dry before installing*
should dry before installing*
UNIT ENCLOSURE
LONG-TERM STORAGE
IMPORTANT
unit.
cause electrical damage.
①
Remove
Use a lint-free cloth soaked with neutral detergent to clean the unit enclosure,
be sure to wring the cloth of excess water. Finish by wiping with a clean dry
cloth.
• Remove the rubber plug at the back of the unit and attach a hose to the drain
outlet. Place the open end of the hose directly over the drain area in your base-
ment fl oor.
• Remove the plug from the bottom drain outlet, this means that all the water in
the bottom drain tray will drain out.
• Keep the appliance running on FAN mode for half a day in a warm room to dry
the appliance inside and prevent mold formation.
• Turn off the appliance and unplug it, wrap the cord and bundle it with tape.
• Remove the batteries from the remote control.
• Clean the air fi lter and reinstall it.
Note: Always store the unit in the vertical position. DO NOT put heavy objects
on top of the unit.
②
Reinstall
15