Danby DPA080C2SDB Guide D'utilisation Et D'entretien page 15

Operating Instructions
REMOTE CONTROL
1. Power Button: Turns the unit on.
2. Mode Button: Each time the button is pressed, the operation mode changes in the following sequence:
3. Temperature Adjustment Buttons: Push these buttons to increase or decrease the indoor temperature setting by
1°C (1°F) increments. When the unit setting is on "Timer," press these buttons to adjust the time. Note: When the unit
is off, the display on the remote will show the set temperature.
4. Fan Button: Used to select the fan speed in four steps:
• After selecting, Cool or Fan mode, pressing the fan button will allow you to set your desired fan speed.
5. Sleep Button: Select this function if you want the unit to maintain a comfortable setting and save energy while you
sleep. The temperature setting will increase by 1°C (2°F) over the next hour and by another 1°C (2°F) over another
hour.
Timer Button: When the unit is on, press the timer button to set the "Timer off" function. The " " and ".5H" icons
6.
will start fl ashing. Within 5 seconds, press the up and down buttons to adjust the time to indicate when you want the
unit to shut off. Release the button after you have achieved the time you desire. Then press the "timer" button again
to confi rm. The " " and ".5H" buttons will stop fl ashing.
When the unit is off, press the timer button to set the "Timer on" function. The " " and ".5H" icons will start fl ashing.
Within 5 seconds, press the up and down buttons to adjust the time to indicate when you want the unit to turn on. Re-
lease the button after you have achieved the time you desire. Then press the "timer" button again to confi rm. The
" " and ".5H" buttons will stop fl ashing.
Note: Pressing the up or down button will increase or decrease the time by 0.5h, holding the up or down button will
allow you to change the time more rapidly.
To cancel the timer, press the "timer" button once to review the remaining time, within 5 seconds press "Timer" again
to cancel the timer function.
Child Lock Function:
You may lock the remote from being used by pressing the "
indicator will illuminate on the remote display. To turn the lock off, press the "
Note: The Child Lock Function is only available for the remote control. If the child lock is on, the buttons on the units con-
trol panel still function normally.
Note: When the Child Lock is initiated, the unit does not beep to indicate it is locked, the only indicator is the illumination
arrow on the display panel.
Note: (While the unit is OFF) To change the unit from °C to °F, press the "
Note: To turn the LED display on/off, press "
COOL DRY
AUTO
" and "
" and simultaneously.
11
FAN
" buttons simultaneously on the remote. The lock
" and " " buttons simultaneously again.
" and " " button simultaneously.