Danby DPA080C2SDB Guide D'utilisation Et D'entretien page 12

Installation Instructions
INSTALLATION IN A
SLIDING SASH
WINDOW
1. Measure the adhesive foam seal to fi t the windowsill. Cut the foam seal (adhe-
sive type) to the proper length and attach it to the window frame.
2. Adjust the length of the window slider kit according to the height of the window,
shorten the adjustable window kit if the height of the window slider is less than
70 cm (27.6 inches). Open the window sash and place the window slider kit on
the windowsill.
3. Cut the foam seal (adhesive type) to the proper length and attach it to the top of
the window. Close the sliding sash securely against the window.
4. Cut the foam seal to an appropriate length and seal the open gap between the
top window sash and outer window sash.
8
Window
Kit
Foam
Seal
Foam
Seal
Foam seal
(adhesive type)
70 cm - 203 cm
27.6 inches -
80 inches