Exhaust Hose Installation; Important; Water Drainage - Danby DPA140HEAUBDB Guide D'utilisation Et D'entretien

Installation Instructions

EXHAUST HOSE INSTALLATION

The exhaust hose and adaptor must be installed or removed in accordance with the
usage mode.
COOL, DRY, HEAT or AUTO mode
FAN
1. Install the window exhaust adaptor onto the exhaust hose as
shown in Fig. A. Refer to the previous pages for window kit
installation.
2. Insert the exhaust hose into the rear air outlet opening Fig. A.
• The hose can be compressed or extended moderately according
to the installation requirement, but it is desirable to keep the hose
length to a minimum.

IMPORTANT

DO NOT OVER BEND THE HOSE

WATER DRAINAGE

• During DRY modes, remove the drain plug from the back of the unit, attach the drain hose to the hole. Place the open
end of the hose directly over the drain area in your basement fl oor. Please refer to Fig. 5.
• For small amounts of water, remove the drain plug and place a pan under the drain outlet as shown in Fig. 4.
NOTE: Make sure the hose is secure
so there are no leaks. Direct the hose
toward the drain, making sure that
there are no kinks that will stop the wa-
ter from fl owing. Place the end of the
hose into the drain and make sure the
end of the hose is down to let the water
fl ow smoothly. (see Fig. 6). Never raise
it. (See Fig 7).
NOTE: When operating or draining wa-
ter, always protect carpeting or fl oors
from possible water spillage.
NOTE: Be sure to reinstall the bottom
drain plug before using the unit.
Install
Remove
Drain outlet
Drain plug
Drain pan
16
Drain plug
Drain hose
Drain outlet