Hendi 976722 Manuel De L'utilisateur page 8

Temperature control
The temperature is regulated by a knob with an im-
printed temperature scale. Possible temperature
setting in the range from 50 to 210°C. As soon as
Sealing process
Ensure that you are familiar with the safety re-
quirements of use. Start the sealing process, ac-
cording to the following description:
1. Place the filled container in the frame hole.
2. Pull the foil over the container so that it is
completely covered with the foil.
Cleaning and maintenance
Cleaning
After the appliance has cooled down, remove the
remains of the packed products with a soft brush.
If necessary, wash off the dirt with a soft sponge,
lightly moistened with water and detergent. Do not
Repair
In the case of malfunctions immediately stop us-
ing the appliance and disconnect it from the power
EN
source.
Check the answers to frequently asked questions
Spare parts
If you need access to spare parts during operation, contact your distributor.
FAQ
a. Can I replace the matrix to use a different type
of container?
Yes. Replacing the matrix is easy. Remove the ex-
isting matrix and insert a new one.
ATTENTION! Be careful not to burn yourself on the
surface of the hot heating plate.
b. Can I use the same matrix for different shapes
of containers?
Yes, however, this is only possible if the container
has one compartment and the length and width of
the different containers are exactly the same. If
8
the heating plate heats up to the set temperature,
the light on the side of the housing will goes off.
3. Grasp the cover handle and close the cover.
4. Wait 1-3 seconds. Foil welded along the edges
of the tray.
5. After finishing the sealing process - open the
cover and take out the closed container.
use products not intended for this type non-stick
coating (see the product sheet of the cleaner).
Remove any impurities from the hob with a soft
sponge when the machine is cool.
in Chapter "FAQ" and see the descriptions of possi-
ble solutions in Chapter "Troubleshooting".
If the problem persists, contact your distributor.
there are any divisions in this area, they will not
be welded.
c. Where can I order new matrix?
Contact your distributor
d. Can I order custom designs containers?
Yes, but the quantity ordered must be very large.
The cost of making a matrix and a frame for an
atypical container must be economically justified.
e. Is it possible to use larger capacity containers?
Yes, please contact your distributor.