Electrical Connection; Operation; Operations Preparation - Holzmann BF16V Mode D'emploi

17.2

Electrical connection

Dangerous electrical voltage! Connection of the machine as well as electrical
inspections, maintenance and repair may only be carried out by qualified personnel or
under the supervision and supervision of a qualified electrician!
1. Check that the neutral connection and protective earthing are functioning properly
2. Check that the supply voltage and current frequency correspond to the specifications of
the machine
A deviation from the value of the supply voltage of ± 5% is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
3. Find the required cross-section of the supply cable (it is recommended to use a cable type
H07RN (WDE0282), taking measures to protect against mechanical damage) in a current
capacity data sheet.
4. Make sure that the power source is protected by a residual current circuit breaker.
5. Connect the unit only to a properly grounded outlet.
6. When using an extension cable, make sure that it is dimensioned appropriately for the
connected load of the machine (the connected load can be found in the technical data).
You can find the correlation between cable cross-section and cable length in specialist
literature or consult an electrician.

OPERATION

18.1

Operations preparation

Check screw connections
Check all bolted connections and tighten if necessary.
Before starting to work
Lubricate all lubrication points
Remove unused tools / parts
Make sure that the vice and the workpiece are
properly fastened.
Check that the spindle speed has been
selected correctly and that the maximum
drilling/milling diameter is within the technical
limits.
Make sure that there are no chips on the
sliding surfaces.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
NOTE
Deviation of the supply voltage and current frequency
After work have finished
Disconnect the machine from the power
supply.
Remove tools from the machine
Clean and lubricate the machine.
Cover the bare surfaces on the machien with a
corrosion protection agent to avoid corrosion.
OPERATION
33
BF16V