Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CLEANING
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
MAINTENANCE
Danger due to electrical voltage! Handling the machine with the power supply up may
result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, any faults
or defects which may affect the safety of the user must be rectified immediately!
Before each start-up, make sure that the safety devices are in perfect condition and
•
function properly.
Check all connections for tightness at least once a week.
•
•
Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
•
Use only proper and suitable tools.
Only use original spare parts recommended by the manufacturer.
•
20.1
Inspection and maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before start of work or
after every maintenance
or servicing
Weekly
Annually
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE
WARNING
Component
Cable and plug
Screw connections
Moving parts
Guideways
Spindle
Crosstable
What to do?
Check for damage and replace if
necessary
Check for tightness
Lubricate
Lubricate
Lubricate with gear grease
Check parallelism
CLEANING
40
BF16V
Publicité
Table des Matières
