Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not work on the machine if it is tired, not concentrated or under the influence of
•
medication, alcohol or drugs!
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
15.5
Electrical safety
•
Make sure that the machine is earthed.
Only use suitable extension cords.
•
Proper plugs and sockets reduce the risk of electric shock.
•
The machine may only be used if the power source is protected by a residual current circuit
•
breaker.
Before connecting the machine turn the main switch to position "0".
•
15.6
Special safety instructions for milling machines
Secure the workpiece to be machined against entrainment by the tool. Use a machine vice
•
or clamping claws for clamping.
Remove the clamping key from the chuck after each tool change.
•
Do not wear gloves when working on rotating parts!
•
Keep sufficient distance from all rotating parts.
•
•
Switch off the machine before measuring the workpiece.
Never remove chips by hand! Use a chip hook, rubber wiper, hand brush or brush.
•
When using cooling lubricants, observe the manufacturer's instructions and, if necessary,
•
use a skin protection agent.
15.7
Hazard Warnings
Despite the intended use, certain residual risks remain.
Formation of a flow chip
•
-
This wraps around the forearm and causes severe cuts.
Throwing away workpieces or tools at high speed.
•
-
Always check workpieces for suitability and clamp them securely and firmly
Risk of electric shock if incorrect electrical connections are used.
•
•
Risk of tripping due to supply lines on the floor.
-
Properly route supply lines and cables
-
Mark unavoidable tripping hazards yellow-black
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed. Due to the design and construction of the machine,
hazardous situations may occur when handling the machines, which are identified in these
operating instructions as follows:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
DANGER
WARNING
CAUTION
SAFETY
30
BF16V
Publicité
Table des Matières
